It's obvious I should change the path, but that doesn't generally seem to do the trick. A Weekly Journal of Medicine and Surgery5436319031903The following values have no corresponding Zotero field: auth-address: New Yorkfile://localhost/Users/ilja/Sync/Publications/Research%20Library/Anon%20-%201903%20-%20The%20Diplodocus%20Carnegiensis.pdf Research Literature.bdbBookends561817AnonThe Diplodocus CarnegiensisMedical Record. (That is what I've done with the Tux figurine bookends.) That reduces the number of files to pass along, but "use" is apparently a common technique, and I wanted to be able to explain the logic as I understand it.Hi, thanks for replying - some expert advice would be very welcome. Alternatively, you could copy the used file's contents and make it a module within the main file. Since the logo needed to be specifically positioned, "use" was appropriate. Include automatically runs the included commands as if they were part of the main file which, in this case, would simply put the GNU logo in the center on the x/y crosshairs. "Use" makes the contents of the file available in the form of a module. Gnu(2) // This is the module "imported" earlier in that case, eliminate the part of the bookend file that positions the logo. Of course, maybe you don't want to use any logo. See how it is done in the bookends Tux file or the bookends GNU logo file. I'll leave it to you to read through the SCAD code if you plan to add your own logo or figure. They must overlap, at least a little bit or be separate on the print surface. That error basically means a part of the design doesn't properly overlap parts. When you position the figure, make sure to set it so it is a millimeter or so of solid overlap so it is embedded into the flat slab, otherwise it will give you a warning about "2-manifold" errors. I like GNU/Linux and had earlier made a version of Tux, the Linux mascot. You can use any available SCAD file to put a 3D print figurine standing on the outer slab. The outside, thicker portion of the flat slab offers another option. which makes the imported file available as a module which can be scaled and moved into place to fit on the vertical bookmark slab. The SCAD file can then be added to the bookend code. Fortunately, I use Inkscape, a Free Software graphic design tool which can export to OpenSCAD files. Manually constructing a fancy polygon is too tough for me. Most of such logos can be made as a fancy polygon, something OpenSCAD works well with. Then I went on to make some other versions for some friends.įor this style of bookend, you will need to find or make a logo. Nope! If I am going to make my own bookends, I want something fancier. Some like these are available for about $4.00 There's very little to the design, a thin slab to go under the books and a vertical, thicker slab with rounded corners, but if that's all you want, go to the office supply store. These bookends make a nice organizer for the current paperbacks and hard covers. When I finally get to reading a book, I keep it in a prominent place on a table or dresser. In these times of ebooks and mobile technology, I find that I still read many printed paper books, some from the local library and some which sit in my TBR pile.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |